Flex-a-lite 365 Dual Electric Fan User Manual download pdf

DIAGRAM A

Allen Cap Bolt

Lock Washer

Flat Washer

Spacer

(if needed)

Scirocco Radiator

Dual Electric Fan #365

“Grin Scirocco Radiator ” Installation:

1. Assemble the Flex-a-lite model 365 Scirocco fan according to the instructions, then follow

these directions for adding the additional set of holes in the mounting brackets.

2. Center the fan assembly between the two upper fan mounts on the radiator side tanks and

fasten using the bolts provided.

3. Mark lower mounting hole locations on the fan assembly mounting anges so they line up

with the lower set of fan mounts on the radiator tanks.

4. Remove fan assembly from radiator.

5. Use le or drill to elongate the holes to t the Grin radiator holes.

6. Fasten fan assembly to radiator using the bolts, lock washers and at washers provided.

Assembly & Mounting Instructions

1. Fan blades are factory mounted as pullers.

To use as a pusher simply slide E-clips o the ends of the motor shafts, reverse blades

and slide E-clips back into position on the ends of the motor shafts.

2. For puller mode attach the black wires to

a positive 12 volt power source and the red

wires to ground. For pusher mode attach the

black wires to ground and the red wires to a

positive 12 volt power source.

3. Mount the Flex-a-lite fan/shroud assembly

to the radiator using the spacers*, bolts,

at washers and lock washers provided

(Diagram A). Always check to make sure

there is sucient clearance for the bolt

threading into the radiator mounting

bosses so that it does not bottom out

and crack the radiator. If sucient clearance

does not exist, use a shorter bolt or a

spacer under the head of the bolt.

*Spacers are used between the bracket and mounting bosses on radiators

where the mounting bosses on one side of the radiator are shorter than

the other. The spacers allow the shroud to lay at on the radiator cor

for even support and a good seal.

Scirocco O.E. Fan Replacement Instructions

1. Disconnect the battery ground cable.

2. Disconnect the fan motor wiring connector.

3. Remove the (4) shroud retaining bolts.

4. Remove the shroud and fan assembly from the car.

5. Install Flex-a-lite fan/shroud assembly as described above.

6. Fans can be wired by splicing into existing fan wiring harness. For increased control of fan,

purchase Flex-a-lite illuminated Switch #31148 or Adjustable Temperature Sensor #31147.

“Grin Scirocco Radiator ” Installation:

1. Assemble the Flex-a-lite model 365 Scirocco fan according to the instructions, then follow

these directions for adding the additional set of holes in the mounting brackets.

2. Center the fan assembly between the two upper fan mounts on the radiator side tanks and

fasten using the bolts provided.

3. Mark lower mounting hole locations on the fan assembly mounting anges so they line up

with the lower set of fan mounts on the radiator tanks.

4. Remove fan assembly from radiator.

5. Use le or drill to elongate the holes to t the Grin radiator holes.

6. Fasten fan assembly to radiator using the bolts, lock washers and at washers provided.

Disconnect the battery ground cable.1.

Disconnect the fan motor wiring connector.2.

Remove the (4) shroud retaining bolts.3.

Remove the shroud and fan assembly from 4.

the car.

Install Flex-a-lite fan/shroud assembled as 5.

described above.

Fans can be wires by slicing into existing fan 6.

wiring harness. For increased control of fan

purchase Flex-a-lite illuminated Switch #31148

or Adjustable Temperature Sensor #31147.

Fan blades are factory mounted as pullers. To use as a pusher simply slide E-clips off the ends 1.

of the motor shafts, reverse blades and slide E-clips back into position on the ends of the motor

shafts.

For puller mode attache the black wire to a positive 12 volt power source and the red wires to 2.

ground. For pusher mode attach the black wires to ground and the red wires to a positive 12 volt

power source.

Mount the Flex-a-lite fan/shroud assembly to the radiator using the spacers*, bolts, washers and 3.

lock washer provided (Diagram A). Always check to make sure there is sufcient clearance for

the bolt threading into the radiator mounting b bosses so that it does not bottom out and crack the

radiator. If sufcient clearance does not exist use a shorter bolt or a spacer under the head of the

bolt.

*Spacers are used between the bracket and mounting bosses on radiators where the mounting

bosses on one side of the radiator are shorter than the other. The spacers allow the shroud to lay at

on the radiator core for even support and a good seal.

Assembly & Mounting

Instructions:

Center the fan assembly between the two upper fan mounts on the radiator side tanks and fasten 1.

using the bolts provided.

Mark lower mounting hole locations on the fan assembly mounting anges so they line up with the 2.

lower set of fan mounts on the radiator tanks.

Remove fan assembly from radiator.3.

Use le or drill to elongate the holes to t the Grifn radiator holes.4.

Fasten fan assembly to radiator using the bolts, lock washers, and at washers provided.5.

Scirocco O.E. Fan Replacement

Instructions:

“Grifn Scirocco Radiator ”

Installation:

The Flex-a-lite Limited Warranty

Flex-a-lite Consolidated, 7009-45th St. Ct. E. Fife, WA 98424, Telephone No. 253-922-2700, warrants to the original purchasing user, that all Flex-a-lite

products to be free of defects in material and workmanship for a period of 365 days (1 year) from date of purchase. Flex-a-lite products failing within

365 days (1 year) from date of purchase may be returned to the factory through the point of purchase, transportation charges prepaid. If, on inspection,

cause of failure is determined to be defective material or workmanship and not by misuse, accidental or improper installation, Flex-a-lite will replace the

product free of charge, transportation prepaid. Flex-a-lite will not be liable for incidental, progressive or consequential damages. Some states do

not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives

you speciﬁc legal rights and you may have other rights, which vary from state to state. The Flex-a-lite warranty is in compliance with the Magnuson-Moss

Warranty Act of 1975.

Rev. 11-08-12 #99966 Page 1 of 1

Summary of Contents

Page 1 - Dual Electric Fan #365

DIAGRAM AAllen Cap BoltLock WasherFlat WasherSpacer (if needed)Scirocco Radiator Dual Electric Fan #365“Grin Scirocco Radiator ” Installation: 1. A

Comments to this Manuals

No comments

Flex-a-lite 365 Dual Electric Fan User Manual

Browse online or download User Manual for For the car Flex-a-lite 365 Dual Electric Fan. Flex-a-Lite 365 Dual Electric Fan User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Flex-a-lite 365 Dual Electric Fan